I want to also report that I did replace the tilt cylinders and used these Magister cylinders. I used the 2 inch by 24 inch cylinder for the tilts and 2 inch x 36 inch on the lift cylinders. On the rod end of the tilts, I actually had to shave off about 1/8 inch on both sides to get the cylinder to fit into the slot. I used a reciprocating saw and it cut easy.
Very happy with the results so far. Have moved quite a few things with my 500 loader since installing and no issues. The price was around $221 and I had to do a back order of a few weeks. With fittings, I sunk about $900 into replacing all four cylinders. It would have cost 2 or 3 times that if I were to fix my original cylinders.
I am holding onto the original 500 loader cylinders for now in case I want to make my 190 completely original someday.
Topic Options
Post Options
Thanks(0)
