This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Model B cam bearing holes
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
00transamnh View Drop Down
Silver Level
Silver Level


Joined: 15 Sep 2016
Location: Maine
Points: 55 		Post Options Post Options   Thanks (0) Thanks(0)   Quote 00transamnh Quote  Post ReplyReply Direct Link To This Post Topic: Model B cam bearing holes
    Posted: 09 Oct 2016 at 2:36pm
Hey folks,

I have a 1940 Model b that I am rebuilding the engine on and need some expertise. I have new cam bearings installed in the block and when in position the oil holes between the block and cam bearings do not line up. Approximately 1/2 the hole is covered by the bearings at all 3 locations. Is this normal or do I have cam bearings wirh holes that are off location? I assume what is exposed of the oil hole is sufficient for oiling the cam but want to make sure
Back to Top
Sponsored Links


Back to Top
00transamnh View Drop Down
Silver Level
Silver Level


Joined: 15 Sep 2016
Location: Maine
Points: 55 		Post Options Post Options   Thanks (0) Thanks(0)   Quote 00transamnh Quote  Post ReplyReply Direct Link To This Post Posted: 10 Oct 2016 at 9:53am
Bump-engine build on hold. Any experience with this out there?
Back to Top
PaulB View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Rocky Ridge Md
Points: 4727 		Post Options Post Options   Thanks (0) Thanks(0)   Quote PaulB Quote  Post ReplyReply Direct Link To This Post Posted: 10 Oct 2016 at 10:00am
just run a drill bit in to open up the holes to match the block.
If it was fun to pull in LOW gear, I could have a John Deere.
Real pullers don't have speed limits.
If you can't make it GO... make it SHINY
Back to Top
Dick L View Drop Down
Orange Level
Orange Level
Avatar

Joined: 12 Sep 2009
Location: Edon Ohio
Points: 5087 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Dick L Quote  Post ReplyReply Direct Link To This Post Posted: 10 Oct 2016 at 2:42pm
The holes are to oil the main Bearings. They need to be open.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.094 seconds.


Help Support the
Unofficial Allis Forum