This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Looking for special tool
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
JimWenigOH View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: NC Ohio
Points: 1153 		Post Options Post Options   Thanks (0) Thanks(0)   Quote JimWenigOH Quote  Post ReplyReply Direct Link To This Post Topic: Looking for special tool
    Posted: 29 Jul 2012 at 4:10pm
Anyone have the special socket for the Gleaner 9/16" feeder beater fingers, AC TP 1007, that I could use or buy?
Back to Top
Sponsored Links


Back to Top
SteveM C/IL View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Location: Shelbyville IL
Points: 8077 		Post Options Post Options   Thanks (0) Thanks(0)   Quote SteveM C/IL Quote  Post ReplyReply Direct Link To This Post Posted: 29 Jul 2012 at 4:18pm
You can cut a deep well socket in two and weld a length of pipe in between. I just worked through the inspection holes with a hand wrench.Put a little blue loctite on new ones. Can't remember if I was able to get a box end over the end with the guide out or not.
Back to Top
XT in pa View Drop Down
Orange Level
Orange Level
Avatar

Joined: 21 Apr 2011
Location: hickory pa
Points: 711 		Post Options Post Options   Thanks (0) Thanks(0)   Quote XT in pa Quote  Post ReplyReply Direct Link To This Post Posted: 29 Jul 2012 at 9:39pm
i used a pipe wrench but i replaced it and the new one had a hex at the top it was 5/8 on f2
190XT,D17and 7045
Back to Top
JimWenigOH View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: NC Ohio
Points: 1153 		Post Options Post Options   Thanks (0) Thanks(0)   Quote JimWenigOH Quote  Post ReplyReply Direct Link To This Post Posted: 30 Jul 2012 at 7:52pm
Never mind.  My new fingers are 5/8" with two flats at 1/2" wide on the end, and I don't know if it would use the same tool as the 9/16" fingers. I will grind out a 1/2" square socket to work.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.055 seconds.


Help Support the
Unofficial Allis Forum