![]() |
This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | |||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
Timing ignition |
Post Reply ![]() |
Author | |
Wot ![]() Bronze Level ![]() Joined: 16 Sep 2009 Location: N Points: 149 |
![]() ![]() ![]() ![]() ![]() Posted: 13 Dec 2019 at 3:01pm |
Hi guys,
I have a question in order to fine tune the ignition of an A / 20-45 engine. The repair manual says: SPARK on flywheel indicating the point where contact points begin to open for nr 1. Is this while cranking the engine or with engine running? Where should SPARK or CENTER on the flyweel need to stand; is it in center of the gap? Or is there a point to line it with? Thanks! Edited by Wot - 13 Dec 2019 at 3:04pm |
|
![]() |
|
Sponsored Links | |
![]() |
|
HoughMade ![]() Orange Level ![]() ![]() Joined: 22 Sep 2017 Location: Valparaiso, IN Points: 691 |
![]() ![]() ![]() ![]() ![]() |
"Center" always mean when cylinder #1 is at Top Dead Center on the power stroke.
On other Allis tractors (I hedge because I have never dealt with your model) "Spark" would mean when the plug should fire when the engine is running at normal speed, some degrees before the piston reaches TDC.
|
|
1951 B
|
|
![]() |
|
MattLF9 ![]() Bronze Level ![]() Joined: 27 Nov 2009 Location: Minnesota Points: 187 |
![]() ![]() ![]() ![]() ![]() |
I assume it's static timing.
Doubt they had timing lights back then but I could be wrong. |
|
A little CQB never hurt anybody.
|
|
![]() |
|
john(MI) ![]() Orange Level ![]() ![]() Joined: 12 Sep 2009 Location: SE MI Points: 9263 |
![]() ![]() ![]() ![]() ![]() |
Sure they did, they used kerosene! ![]() ![]() ![]() I'm thinking you are bringing up to TDC on cylinder one by hand, not running or cranking.
|
|
D14, D17, 5020, 612H, CASE 446
|
|
![]() |
|
LeonR2013 ![]() Orange Level ![]() ![]() Joined: 01 Jan 2013 Location: Fulton, Mo Points: 3500 |
![]() ![]() ![]() ![]() ![]() |
Yes when the engine is just ready to fire #1 you'll want the rotor to be pointing at #1 in the dist. cap. which is about 1:30. You should be close enough to start and run. If you have 12V timing light just power it up with a 12V batt. sitting close by. Hope this helps. Leon
|
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |