This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


8030 questions
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
orangepower View Drop Down
Silver Level
Silver Level


Joined: 22 Nov 2009
Location: swohio
Points: 96 		Post Options Post Options   Thanks (0) Thanks(0)   Quote orangepower Quote  Post ReplyReply Direct Link To This Post Topic: 8030 questions
    Posted: 09 Mar 2011 at 8:32pm
i been looking at 8030's both tractors lose there prime, why, ?  is this a common problem? they been sitting on a dealers lot. next one 8030 has a problem once you get it primed, it will only run from 1000 to 1300 rpms, then it will flutter out and die if you accelerate. they think its injection pump. what do you think? how much for injection pump rebuild? thanks for replies.
45 diesel puller, 45 gas puller, ca puller
Back to Top
Sponsored Links


Back to Top
niel ev View Drop Down
Silver Level
Silver Level


Joined: 04 Feb 2010
Points: 189 		Post Options Post Options   Thanks (0) Thanks(0)   Quote niel ev Quote  Post ReplyReply Direct Link To This Post Posted: 09 Mar 2011 at 8:48pm
It could be enjection pump or something as simple as the rubber o-rings have gotten brittle  Niel
Back to Top
Dans 7080 View Drop Down
Orange Level
Orange Level


Joined: 05 Feb 2010
Points: 1146 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Dans 7080 Quote  Post ReplyReply Direct Link To This Post Posted: 10 Mar 2011 at 12:00am
I have a 7040 that did the same thing. I replaced all the O-rings and still no change. Looking further in depth I had 2 lines rubbing, one had a hole so small that fuel wouldnt leak but would suck enough air. It took 2 people to start it, one to crank and one to push the primer and spray ether.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.109 seconds.


Help Support the
Unofficial Allis Forum