6040, 160 Clutch replacement problems

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

I have split this new to me tractor because the clutch was stuck. When I separated the tractor the center clutch shaft stayed in the clutch.The roll pin in the other end has sheared off. This is in a 6040. Any tricks or knowledge on how to get the sheared pin out of the transmission?

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Yellowmater Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 12 May 2022 Location: Virginia Points: 2	Post Options Post Reply Quote Yellowmater Report Post Thanks(0) Quote Reply Topic: 6040, 160 Clutch replacement problems Posted: 20 hours 39 minutes ago at 5:08pm
	I have split this new to me tractor because the clutch was stuck. When I separated the tractor the center clutch shaft stayed in the clutch.The roll pin in the other end has sheared off. This is in a 6040. Any tricks or knowledge on how to get the sheared pin out of the transmission?

Sponsored Links

AC720Man Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 10 Oct 2016 Location: Shenandoah, Va Points: 4951	Post Options Post Reply Quote AC720Man Report Post Thanks(0) Quote Reply Posted: 4 minutes ago at 1:43pm
	I split my 160 a few years ago to replace both clutches but didn’t have an issue with the shaft. It must have been stuck tight in the clutch for it to snap the roll pin. Will dig out my manual to try to get you an answer but I would say you have a big job ahead of you. Probably have to remove the top off the transmission? Looking at your picture, the lower shim is turned sideways or inward. The 2 shims at the top are correct with the flat side facing out. Could very well be the reason the clutch won’t release. It only takes one of the 6 shims to be facing the wrong way for the clutch to not release. Trust me I know, had to split mine again because of that issue. Depending on how worn the pto clutch is there should be 3 shims under each of the 6 bolts unless they have been removed over time for clutch wear. They are removed when it becomes difficult to engage/disengage the pto clutch. 1 shim under each bolt is removed until proper clearance is achieved. Surprised at the amount of rust/dirt all over the clutch assembly while being inside the bell housing.
	1968 B-208, 1976 720 (2 of them)Danco brush hog, single bottom plow,52" snow thrower, belly mower,rear tine tiller, rear blade, front blade, 57"sickle bar,1983 917 hydro, 1968 7hp sno-bee, 1968 190XTD