| Author |
 Topic Search  Topic Options
|
John426 
Silver Level
Joined: 14 Aug 2012
Location: France
Points: 291
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: Hydraulic lift capacity D10 D12 D14 D17
Posted: 18 Oct 2024 at 4:47am |
Hi i an looking for the lift capacity of the old tractor.
What is the lift capacity for D10 D12 D14 D17 ?
|
 |
|
Sponsored Links
|
|
|
DrAllis
Orange Level Access
Joined: 12 Sep 2009
Points: 20523
|
Post Options
Thanks(0)
Quote Reply
Posted: 18 Oct 2024 at 6:40am |
|
There never was (to my knowledge) an official lifting weight rating ever published. I do know a D-17 series 1 will pick up a fully mounted 4 bottom plow and that could be as high as 1400 lbs with the rear bottom a long ways behind the tractor. A series 3 D-17 will lift more than a series 1 because of a larger lift ram. A series 4 will lift even more yet. A D-14 by comparison will lift an 800 lb plow. D-10/12 less than that. Every model, if their hydraulic system is 100% good, can lift enough to raise the front wheels off the ground without any front end weights.
|
|
PaulB
Orange Level
Joined: 12 Sep 2009
Location: Rocky Ridge Md
Points: 4740
|
Post Options
Thanks(0)
Quote Reply
Posted: 18 Oct 2024 at 2:58pm |
I have 1500 pound on a Plow hitch on the back of my D15 for counterbalance with the front end loader it will pick it up easily.
My D10 series I and the CAs will lift 1000 pound on the Snap-Coupler Carry-All with sufficient front weights added
|
|
If it was fun to pull in LOW gear, I could have a John Deere.
Real pullers don't have speed limits.
If you can't make it GO... make it SHINY
|
|
Ky.Allis
Orange Level
Joined: 31 Jan 2010
Location: Kentucky
Points: 1003
|
Post Options
Thanks(0)
Quote Reply
Posted: 18 Oct 2024 at 4:37pm |
|
I had a "17-Series 3" and it would not lift a round bale from a Vermeer 605F baler. At least not to the point where you would feel safe with it. Not much lift capacity at all in my opinion. And this was dry grass hay.
|
|
steve(ill)
Orange Level Access
Joined: 11 Sep 2009
Location: illinois
Points: 81240
|
Post Options
Thanks(0)
Quote Reply
Posted: 18 Oct 2024 at 4:41pm |
|
Steve, you bales could be 16-1700 # and the weight is quite a bit back from the hitch ... right ?
|
|
Like them all, but love the "B"s.
|
|
DrAllis
Orange Level Access
Joined: 12 Sep 2009
Points: 20523
|
Post Options
Thanks(0)
Quote Reply
Posted: 18 Oct 2024 at 5:42pm |
|
And, the 3700 psi hyd pump spec may have only been 2500 psi..........
|
|
jaybmiller
Orange Level Access
Joined: 12 Sep 2009
Location: Greensville,Ont
Points: 22472
|
Post Options
Thanks(0)
Quote Reply
Posted: 18 Oct 2024 at 6:16pm |
MY D-14 could lift 3000# on the rear. lift for a front end loader would depend on WHICH loader was installed My loader D-14 would lift an 1800# pumpkin....
|
|
3 D-14s,A-C forklift, B-112
Kubota BX23S lil' TOOT( The Other Orange Tractor)
Never burn your bridges, unless you can walk on water
|
|
John426
Silver Level
Joined: 14 Aug 2012
Location: France
Points: 291
|
Post Options
Thanks(0)
Quote Reply
Posted: 19 Oct 2024 at 3:22am |
|
For example on the English ED40 , the manual says that the pressure is 2500 PSI, 5 gallons /mn and lift capacity tested at 2300 lbs
|
|
Mikez
Orange Level Access
Joined: 16 Jan 2013
Location: Usa
Points: 8391
|
Post Options
Thanks(0)
Quote Reply
Posted: 19 Oct 2024 at 8:21am |
|
What do you want to lift.
|
|
HudCo
Orange Level
Joined: 29 Jan 2013
Location: Plymouth Utah
Points: 3542
|
Post Options
Thanks(0)
Quote Reply
Posted: 20 Oct 2024 at 8:38pm |
|
they will lift alot more than they are meant to when the 70 year old pumps are freshened up and make more than 1500 psi
|
|
