This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | ||||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
Allis B new main bearing Question |
Post Reply |
Author | |
gman54313
Silver Level Joined: 23 Nov 2019 Location: Green Bay WI Points: 66 |
Post Options
Thanks(0)
Posted: 19 Jan 2020 at 5:51pm |
I finally got some time to mic my newly ground crank and the ID of my new .030 bearings and noticed that all the bearing halves with the exception of the one with the thrust have the word upper stamped on them? Is this right? Should I have other halves stamped lower? I will be contacting the supplier tomorrow. But thought I would but the question out there. I did verify that the part number on the bearing is correct .030 but the stamped "upper has me stumped. I can say the ID of the two "uppers" put together measured 2.1966 top to bottom and my main journal is at 2.219
Greg |
|
Sponsored Links | |
Dick L
Orange Level Joined: 12 Sep 2009 Location: Edon Ohio Points: 5082 |
Post Options
Thanks(0)
|
Just one half going in as in the picture. Once you start to install the crankshaft you will understand.
Edited by Dick L - 19 Jan 2020 at 6:10pm |
|
Boss Man
Orange Level Joined: 03 Mar 2018 Location: Greenleaf, WI Points: 608 |
Post Options
Thanks(0)
|
Main difference between the uppers and lowers is the drilled oil hole. Make sure the hole matches the hole in the block and you wont have a problem.
|
|
gman54313
Silver Level Joined: 23 Nov 2019 Location: Green Bay WI Points: 66 |
Post Options
Thanks(0)
|
Thank you. I was able to find out the part number is the same for the upper and lower bearing halves except for the main front lower. I just need to get my shims and proceed.
Thanks Greg |
|
Gerald J.
Orange Level Joined: 12 Sep 2009 Location: Hamilton Co, IA Points: 5636 |
Post Options
Thanks(0)
|
The shop manual may have a cue.
http://geraldj.networkiowa.com/Trees/Allis-Chalmers-G-B-C-CA-Service.pdf Gerald J. |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |