This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Construction and other equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Hd11 outer bearings

 Post Reply Post Reply
Author
Message
7060 View Drop Down
Orange Level
Orange Level
Avatar

Joined: 16 Sep 2009
Location: Missouri
Points: 1142
Post Options Post Options   Thanks (0) Thanks(0)   Quote 7060 Quote  Post ReplyReply Direct Link To This Post Topic: Hd11 outer bearings
    Posted: 23 Nov 2019 at 12:19pm
I am doing some maintenance on my hd11E and decided to change the final drive oil. I wanted to pull the caps off the outer bearings and wondered how to check the preload?
Back to Top
Sponsored Links


Back to Top
Lazyts View Drop Down
Orange Level
Orange Level


Joined: 05 Feb 2012
Location: Manitoba
Points: 627
Post Options Post Options   Thanks (0) Thanks(0)   Quote Lazyts Quote  Post ReplyReply Direct Link To This Post Posted: 28 Nov 2019 at 8:51am
The preload is measured by rolling torque with the truck frames and seals removed.  The best you could do short of that would be to pull a couple of shims.
Back to Top
DMiller View Drop Down
Orange Level Access
Orange Level Access


Joined: 14 Sep 2009
Location: Hermann, Mo
Points: 29235
Post Options Post Options   Thanks (0) Thanks(0)   Quote DMiller Quote  Post ReplyReply Direct Link To This Post Posted: 28 Nov 2019 at 12:43pm
THIN Shims as you do not want to cook those.
Back to Top
Tad Wicks View Drop Down
Orange Level
Orange Level
Avatar

Joined: 27 Mar 2011
Location: Shandon, CA
Points: 2160
Post Options Post Options   Thanks (0) Thanks(0)   Quote Tad Wicks Quote  Post ReplyReply Direct Link To This Post Posted: 22 Dec 2019 at 2:55pm
What you might do, is remove all the shims and then put the cap back on, torque to 15-20 inch pounds, use a feeler gauge around the shim area and average the gap then match that gap with the shims and add about .015 inch then torque to 35-40 foot pounds. Remember to tight is worse than to loose. Just my thoughts.
Back to Top
LeonR2013 View Drop Down
Orange Level
Orange Level
Avatar

Joined: 01 Jan 2013
Location: Fulton, Mo
Points: 3500
Post Options Post Options   Thanks (0) Thanks(0)   Quote LeonR2013 Quote  Post ReplyReply Direct Link To This Post Posted: 22 Dec 2019 at 9:35pm
After you set the preload see if you can shake them at all. If a little loose, tighten them a tad and check again. If no shake and turns free, buckle her up. Run it a while then get your lazy butt off the machine and see if they're getting warm or hot. Recheck. (Requires getting off again. You get the procedure.)    Leon
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.059 seconds.


Help Support the
Unofficial Allis Forum