This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | ||||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
Allis 200 power director |
Post Reply |
Author | |
Romaninmi
Silver Level Joined: 24 Nov 2009 Location: Fowler MI Points: 87 |
Post Options
Thanks(0)
Posted: 02 Nov 2015 at 7:22pm |
I went and looked at a allis 200 today it has only been used about 20 hrs in the last 3 or 4 yrs sits outside runs like a top trans does not jump out of 3 rd gear but the power director lever will not go into low range my question is this just from sitting around or is is something internal the current owner has very little tractor knowledge only used it for scraping snow and pulling out stuck trucks in his driveway any help on this would be great
|
|
Sponsored Links | |
critter
Silver Level Access Joined: 13 Nov 2013 Location: Ohio Points: 254 |
Post Options
Thanks(0)
|
I will bet it is stuck from setting outside.
|
|
MACK
Orange Level Joined: 17 Nov 2009 Points: 7664 |
Post Options
Thanks(0)
|
Do you mean the lever won't move into low posion or won't do any thing in low? MACK
|
|
Romaninmi
Silver Level Joined: 24 Nov 2009 Location: Fowler MI Points: 87 |
Post Options
Thanks(0)
|
It will not move to the low position or n position
|
|
MACK
Orange Level Joined: 17 Nov 2009 Points: 7664 |
Post Options
Thanks(0)
|
I guess you are pushing down on lever before trying to move it. MACK
|
|
Romaninmi
Silver Level Joined: 24 Nov 2009 Location: Fowler MI Points: 87 |
Post Options
Thanks(0)
|
it has the gated lever
|
|
Lynn Marshall
Orange Level Access Joined: 13 Sep 2009 Location: Dana, Iowa Points: 2257 |
Post Options
Thanks(0)
|
Disconnect it at the valve body to see if it's the linkage or the actual valve spool itself.
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |