This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Other Topics > Pulling Forum
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


wd timing
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
bradley6874 View Drop Down
Orange Level
Orange Level


Joined: 05 Sep 2010
Location: salisbury md
Points: 1344 		Post Options Post Options   Thanks (0) Thanks(0)   Quote bradley6874 Quote  Post ReplyReply Direct Link To This Post Topic: wd timing
    Posted: 09 May 2015 at 6:09pm
On a plain wd where do you find the timing marks there is no whole like a 17
You can wash the dirt off the body but you can’t wash the farmer out of the heart and soul
Back to Top
Sponsored Links


Back to Top
ksbowhunter View Drop Down
Orange Level
Orange Level
Avatar

Joined: 28 Aug 2014
Location: Newton Ks.
Points: 212 		Post Options Post Options   Thanks (0) Thanks(0)   Quote ksbowhunter Quote  Post ReplyReply Direct Link To This Post Posted: 09 May 2015 at 8:59pm
Open the small cover at the bottom of the flywheel cover... There is a mark on the flywheel that you want to be in the Middle of that hole, just as the #1 sparkplug fires...(compression stroke).
2-37 WC
37 wf127
37 wf130
Back to Top
bradley6874 View Drop Down
Orange Level
Orange Level


Joined: 05 Sep 2010
Location: salisbury md
Points: 1344 		Post Options Post Options   Thanks (0) Thanks(0)   Quote bradley6874 Quote  Post ReplyReply Direct Link To This Post Posted: 10 May 2015 at 9:44am
thanks I don't have the covers on they weigh to much    didn't look there
You can wash the dirt off the body but you can’t wash the farmer out of the heart and soul
Back to Top
bradley6874 View Drop Down
Orange Level
Orange Level


Joined: 05 Sep 2010
Location: salisbury md
Points: 1344 		Post Options Post Options   Thanks (0) Thanks(0)   Quote bradley6874 Quote  Post ReplyReply Direct Link To This Post Posted: 17 May 2015 at 8:30am
ok are you talking about the tin shield under the motor in front of the flywheel or the clutch inspection hole under the flywheel
You can wash the dirt off the body but you can’t wash the farmer out of the heart and soul
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20528 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 17 May 2015 at 9:53am
The timing marks on the flywheel are on the O.D. of the flywheel at the point where the pressure plate is attached to the flywheel. Remove the small cover for greasing the throwout bearing. You'll see a "pointer" cast into the bellhousing at 6 o'clock straight down to align the flywheel mark with. The flywheel has a TDC mark and a "FIRE" or "F" mark which is 30 degrees BTDC. Normal timing procedure is done at wide open throttle (1700 RPM) to align FIRE mark at that speed.
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20528 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 17 May 2015 at 12:15pm
If this engine has been modified for Pulling, such as raise the compression ratio, total ignition timing usually needs to be retarded from 30 degrees BTDC. How much retarded??? depends on what you have actually done to the engine. Best results are achieved by adjusting the ignition timing on a dyno for maximum performance. One of my tractors is around 16 degrees BTDC and the other is about 20 degrees BTDC.....two completely different configurations.
Back to Top
mgburchard View Drop Down
Orange Level
Orange Level
Avatar

Joined: 14 Sep 2009
Location: Tennessee
Points: 1123 		Post Options Post Options   Thanks (0) Thanks(0)   Quote mgburchard Quote  Post ReplyReply Direct Link To This Post Posted: 17 May 2015 at 2:34pm
O'Brien is the 16 degrees on the 13to 1 cr ?
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.079 seconds.


Help Support the
Unofficial Allis Forum