It's going to be difficult to snake hydraulic hoses in where steel lines were, expecially the ones underneath that go from the valve to the cylinder....it's tight in there.
As CT said, find someone to bend up the lines like the originals; the fittings are standard SAE double-flared hydraulic-type fittings. You could even salvage the ends from the existing lines. If you don't have them, buy some flarenut or "line wrenches". They'll sure make it easier to remove the lines and avoid rounding off the hex corners I think Sears has a good set for not too much.
Topic Options
Post Options
Thanks(0)
