This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Electronic cut out question
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Bull View Drop Down
Orange Level Access
Orange Level Access


Joined: 28 Sep 2010
Location: Lamar, Missouri
Points: 589 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Bull Quote  Post ReplyReply Direct Link To This Post Topic: Electronic cut out question
    Posted: 22 Jun 2011 at 4:33pm
I am wiring up my CA and have purchased an electronic cut out for the generator. I am wiring as original with 6 volt positive ground. My question is do you hook the + terminal on the cut out to the ammeter or the generator? 
Back to Top
Sponsored Links


Back to Top
Wes (VA) View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Elkton, VA
Points: 510 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Wes (VA) Quote  Post ReplyReply Direct Link To This Post Posted: 22 Jun 2011 at 4:38pm
terminal that says BAT on the cut out goes to the ammeter.  I just ran into this putting my CA back to 6Vpos. grd.  The "F"ield is varied by the resistor switch in the dash.  A short jumper wire runs from the GEN terminal of the cut out to the "A"rmature post.  hope this helps.   -Wes
Back to Top
Bull View Drop Down
Orange Level Access
Orange Level Access


Joined: 28 Sep 2010
Location: Lamar, Missouri
Points: 589 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Bull Quote  Post ReplyReply Direct Link To This Post Posted: 22 Jun 2011 at 4:46pm
Thanks Wes for the info!
 
Sam
Back to Top
Gerald J. View Drop Down
Orange Level
Orange Level


Joined: 12 Sep 2009
Location: Hamilton Co, IA
Points: 5636 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Gerald J. Quote  Post ReplyReply Direct Link To This Post Posted: 22 Jun 2011 at 7:23pm
Quick test. Take the fan belt off. Connect wires to cutout, battery, and generator. If the generator motors the cutout is backwards.

Gerald J.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.160 seconds.


Help Support the
Unofficial Allis Forum