7040 Hydraulic Remote Linkage

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic


   
Fixing up the 7040 to use as a planter tractor next year and noticed excessive play in the two hydraulic remote levers.  They both have about 3" of free travel.  In fact, so much free travel that they will not detent in float position (lever hits front of slot in console preventing detent).  I took the side cover off the console and the ball/socket and clamps are in good shape and not loose.  Cables appear to be in good shape also.  Is there a linkage adjustment on or near the valve spool end of the linkage, or what else could be the problem back there?  Thanks for any help  


Edited by dualquads - 28 May 2011 at 9:32pm

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
dualquads Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 12 Dec 2010 Location: Ill Annoy Points: 51	Post Options Post Reply Quote dualquads Report Post Thanks(0) Quote Reply Topic: 7040 Hydraulic Remote Linkage Posted: 28 May 2011 at 9:31pm
	Fixing up the 7040 to use as a planter tractor next year and noticed excessive play in the two hydraulic remote levers. They both have about 3" of free travel. In fact, so much free travel that they will not detent in float position (lever hits front of slot in console preventing detent). I took the side cover off the console and the ball/socket and clamps are in good shape and not loose. Cables appear to be in good shape also. Is there a linkage adjustment on or near the valve spool end of the linkage, or what else could be the problem back there? Thanks for any help Edited by dualquads - 28 May 2011 at 9:32pm

Sponsored Links

DrAllis Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Access Joined: 12 Sep 2009 Points: 21099	Post Options Post Reply Quote DrAllis Report Post Thanks(0) Quote Reply Posted: 28 May 2011 at 9:56pm
	Replace both levers and pins that connect to the spools.

dualquads Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 12 Dec 2010 Location: Ill Annoy Points: 51	Post Options Post Reply Quote dualquads Report Post Thanks(0) Quote Reply Posted: 28 May 2011 at 10:42pm
	Thank you. Those levers on the spool seemed very loose but I didn't have a lot of time today to further investigate. Thanks again!