3 point conversions

Should be bringing home a D 14 this week and i need a 3 point conversion for it.  If any one is using a three point conversion where did you get it from and how is it working?  Looking to order one in the next couple days.

2 different styles,1 is best if you plan on using both Snap Coupler and 3 pt. equipt.(easy to take 3pt adaptor on and off).2nd style is more permanently mounted and not so easy to switch back and forth.Also some models incorporate traction booster and some don't.Best one depends on what you want to do with it.

I have one of the Allis made snap coupler adaptors, and it works well. I have no idea how common they are, but I bought mine at an auction for $10.00, and it collected dust for ten years before i had a tractor with the snap coupler to use it on.

Thanks guys.  I will probably using only 3 point equipment as its easier to find.  The unit at Saginaw Tractors is the one I was really looking at.  Your right it does look pretty beefy.  I was just curious as to what others were using. OK tractors has one for like $325.    Dumb question but is Saginaw Tractor up in Saginaw actually?  I will probably go with this set up. 

On another note,  I mostly plan on using this with a box grader and disc to work up the ground in my riding arena. And aslo brush hog and back blade.

I have one of the snapcoupler wishbones from tonys tractors. Its got cat 2 balls and works real well. Seams to be very strong. you need to rember to take the spreader tube off when you put the snow blower on though or ya bend the PTO when the bank lifts above the upper limit.  I just use the X chain sway control seames to work well. I've also use a post hole digger on it with no problems. When I put the finish mower on I take the top link off. the mower follows the ground better without it. I do install the top link to load on the trailer then take off after I unload.

Here a picture of mine i built after the Saginaw one, i just used fleet farm parts and it turned out really well, and much cheeper, but im also a welder.

Does any one have a picture of the Cross MFG 3 point hitch on their tractor?  How does this one use the traction boost better than the Saginaw one?   I would still like the use of a draw bar, a friend of mine told me there is a bar you can put in the 3 point and still pull wagons.  Only one use these?   Thanks for all your info everyone

My Saginaw allows use of the PTO, and I don't recall one that didn't.  I visited their place, and for the D series, I believe they only have one model.