This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | ||||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
d14 connecting rod position |
Post Reply |
Author | |
mjbower
Silver Level Joined: 04 Oct 2009 Location: Michigan Points: 255 |
Post Options
Thanks(0)
Posted: 12 Jan 2011 at 9:08pm |
do the number one and three conn rod piston pin clamp bolt face the cam and the number two and four face away from the camshaft does this sound right thanks for the help |
|
Sponsored Links | |
Chalmersbob
Orange Level Joined: 11 Sep 2009 Location: Pennsylvania Points: 2122 |
Post Options
Thanks(0)
|
I don't remember if it is those #'s but 2 face one way and yhe other 2 face the opposite way, It's do to the offset for the bearings, Bob
|
|
Dick L
Orange Level Joined: 12 Sep 2009 Location: Edon Ohio Points: 5087 |
Post Options
Thanks(0)
|
Look at the offset on the rod caps. When in doubt watch close as the rod bearing locates on the crankshaft. If it is correct it will be centered on the journal. If it is backwards it will not center and if you attempt to tighten a rod cap it will bind on one side.
The picture will also show you which way they go. |
|
mjbower
Silver Level Joined: 04 Oct 2009 Location: Michigan Points: 255 |
Post Options
Thanks(0)
|
Thanks again for the info the picture for sure refreshed my memory |
|
1946WP
Orange Level Joined: 25 Apr 2010 Location: mn Points: 780 |
Post Options
Thanks(0)
|
short side of rod cap goes toward the main bng. believe it or not they will run when they are in there awrong. my D14 had 2 in wrong when I bought it . It ran but not very well. It had other back yard overhall problems also.
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |