This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Power director help

 Post Reply Post Reply
Author
Message
D171958 View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 03 Aug 2024
Location: Iowa
Points: 20
Post Options Post Options   Thanks (0) Thanks(0)   Quote D171958 Quote  Post ReplyReply Direct Link To This Post Topic: Power director help
    Posted: 5 hours 11 minutes ago at 7:17am
The other day I was putting my d17 series 1 power director together and I got .005 .018 I had put all new clutch linings in wondering if I did something wrong.
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20220
Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 4 hours 60 minutes ago at 7:28am
At each of the three "stations", the total shim thickness is to be .205". So you might have .080" short shims in LOW range......you might have .070" short shims in High range......so then you MUST have .055" in the center (long shims). Your post doesn't make sense the way it is written.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.


Help Support the
Unofficial Allis Forum