| Author |
 Topic Search  Topic Options
|
WD45 
Orange Level
Joined: 20 Sep 2009
Location: STAYNER,ONTARIO
Points: 952
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: TUBE ASSEMBLY 229367 D19
Posted: 20 Sep 2024 at 10:43am |
Wanted one Tube assembly 229367 for D19 item 1 on page 195 of D19 March 1964 dealers parts book. This is one of the lines for power steering.
|
|
Fred Dunlop, G,B,CA, WC,WF, 3 WD45`s,gas, diesel and LP,U,D10 series III, D12,D14,D15 SERIES II,D17 Series IV in Gas and Diesel ,D19 GAS and D21,170 185,210 ,220 an I-600 8070 fwd, 716H and 1920H
|
 |
|
Sponsored Links
|
|
|
tbran
Orange Level
Joined: 14 Sep 2009
Location: Paris Tn
Points: 3291
|
Post Options
Thanks(0)
Quote Reply
Posted: 20 Sep 2024 at 12:25pm |
|
Checked all my sources, NLA - no NOS... D15D D17 D19 all use this , sorry.. looks like inverted male flare - either make one or salvage yards.
|
|
When told "it's not the money,it's the principle", remember, it's always the money..
|
|
ryan(IN)
Orange Level
Joined: 11 Sep 2009
Location: Bluffton,IN
Points: 764
|
Post Options
Thanks(0)
Quote Reply
Posted: 20 Sep 2024 at 12:56pm |
|
If there’s enough straight section of tube on both ends you could get compression fittings that then crimp to hydraulic hose to get it made.
|
|
ryan
1984 8070 FWA,1979 7060,1975 7040,1971 190,1960 D-17D,1957 D-14, 196? D-19G, 1975 5040,1971? 160,1994 R62
|
|
WD45
Orange Level
Joined: 20 Sep 2009
Location: STAYNER,ONTARIO
Points: 952
|
Post Options
Thanks(0)
Quote Reply
Posted: 20 Sep 2024 at 4:25pm |
I had to cut the tube above the 90 degree bend to put a socket on to get the fitting out. Tube was leaking at other end. Had a hose made up but the fitting was too long causing the hose to rub the steering and radius rods.
|
|
Fred Dunlop, G,B,CA, WC,WF, 3 WD45`s,gas, diesel and LP,U,D10 series III, D12,D14,D15 SERIES II,D17 Series IV in Gas and Diesel ,D19 GAS and D21,170 185,210 ,220 an I-600 8070 fwd, 716H and 1920H
|
|
