This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


L3 combine header hyd problem
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Ron(AB) View Drop Down
Orange Level
Orange Level
Avatar

Joined: 27 Dec 2009
Location: Alberta
Points: 957 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Ron(AB) Quote  Post ReplyReply Direct Link To This Post Topic: L3 combine header hyd problem
    Posted: 10 Sep 2024 at 1:46pm
My pickup on the header does not turn anymore. Last few years I would change the drive motor and it would work again, but not this time.

The oil in the system gets too hot!

The hyd pump must be worn and recirculating the oil?

Any suggestions? I don't think Agco sells the pump anymore?
405, 7000, 7050, 8050, 8070, L3, 2300 & 2600 disk
Back to Top
Sponsored Links


Back to Top
Ron(AB) View Drop Down
Orange Level
Orange Level
Avatar

Joined: 27 Dec 2009
Location: Alberta
Points: 957 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Ron(AB) Quote  Post ReplyReply Direct Link To This Post Posted: 12 Sep 2024 at 9:15am
Tore down pump, everything was good except the bushings on the end cap of the pump. 1400 hours on separator seemed like low hours for failure.

Agco parts persons have difficulty finding it because pickup headers are not listed in their parts books and there is no model number on a pickup header.

This takes you to a wrecker or a hyd shop.

The pump is made by Cessna - company owned by Eaton. The pump is discontinued in this configuration - having end ports as compared to side porting. If you're lucky you can get another similar new pump and just swap the end cover with your correct ports. Then you're good to go.
405, 7000, 7050, 8050, 8070, L3, 2300 & 2600 disk
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.047 seconds.


Help Support the
Unofficial Allis Forum