7045 remotes

My 7045 is not sending oil through either spool. i have 3 pt funtion, power steering, and powershift function. Fluid levels are good and filters have been changed. it sounds as if the hydraulic fluid is bleeding by or bypassing somewhere? Please advise?

Thanks! I will check out the flow valve.

Sounds like a lot of worn out linkage or debre under a piolet check.                  MACK

I always have to put mine in float or stop the engine to turn mine. You can reach over the valve and feel the adjuster. You can also see the rod going into the cab. You said it was working slow on another implement. I have unhooked from something with small cylinders like a row marker and have it turned to work not so fast. Forget and hook to a heavy load like a disk andhave to turn turn it faster to ever get it to raise. Thats why i believe thats your problem. Maybe yes maybe no

What exactly have you done ??  Both flow controls should have the LONG side of the roll pin straight down for maxx flow volume from each remote valve. A 3,000 psi gauge connected to the capped tee on the side of the PTO valve will give some of us an indication as to what the pump is doing (or not doing).  600 psi at rest and 2500 psi with any remote lever fully activated are normal numbers.   A 3,000 psi gauge plugged into each remote outlet one at a time would indicate something. With the engine off does each remote lever detent into RAISE....LOWER....FLOAT positions ???