This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Power director clutch
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
John m View Drop Down
Silver Level
Silver Level


Joined: 11 Apr 2020
Location: Wetmore, Mi
Points: 278 		Post Options Post Options   Thanks (0) Thanks(0)   Quote John m Quote  Post ReplyReply Direct Link To This Post Topic: Power director clutch
    Posted: 18 Feb 2022 at 3:15pm
Working on a 190xt power director clutch. When taking the clutch pack off I discovered there are no steel balls beneath the Allen screws that secure it to the shaft. The repair manual says there should be 1/4 Chrome steel balls. Should I just find some balls to put in when reassembly or is they not used anymore? Thanks, John
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 22043 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 18 Feb 2022 at 3:49pm
Steel balls were not used in the very early years and were added as an improvement.
Back to Top
Alvin M View Drop Down
Orange Level
Orange Level


Joined: 24 Jun 2018
Location: PA
Points: 804 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Alvin M Quote  Post ReplyReply Direct Link To This Post Posted: 18 Feb 2022 at 3:51pm
You can use 1/4 chrome balls
Back to Top
John m View Drop Down
Silver Level
Silver Level


Joined: 11 Apr 2020
Location: Wetmore, Mi
Points: 278 		Post Options Post Options   Thanks (0) Thanks(0)   Quote John m Quote  Post ReplyReply Direct Link To This Post Posted: 18 Feb 2022 at 3:54pm
Thanks, I'll find some 1/4 inch balls and put them in when reassembling. The Allen heads weren't very tight when I removed them. This may keep them snugged up.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.094 seconds.


Help Support the
Unofficial Allis Forum