This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Construction and other equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


HD4
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Mike K View Drop Down
Silver Level
Silver Level
Avatar

Joined: 27 Sep 2009
Location: Edgar, WI
Points: 226 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Mike K Quote  Post ReplyReply Direct Link To This Post Topic: HD4
    Posted: 23 Oct 2021 at 6:51pm
Just purchased a HD4 with final drive inoperative on right side when sitting  The cover on the bottom for the final drive is pushed away from the casting. Like the bolts are stretched
Any ideas before I remove the cover
Back to Top
Sponsored Links


Back to Top
pinball View Drop Down
Orange Level Access
Orange Level Access


Joined: 28 May 2014
Location: missouriu
Points: 6102 		Post Options Post Options   Thanks (0) Thanks(0)   Quote pinball Quote  Post ReplyReply Direct Link To This Post Posted: 23 Oct 2021 at 11:16pm
if your lucky and it was hit you might be able to replace it. if it was due to bull drive gear then your probably in for a big job and expensive.  worse scenario is the bearing went out and it let your bull gear start wobbling which possible could mean you have to find a good case. look at the rear drive sprocket and on each side you will see a flat bracket and see if the rear drive sprocket  is touching a bracket. there should be couple inches clearance on both sides. you also can take the plug out of the lower part of the case and see if theres is any metal in there.
Back to Top
Coke-in-MN View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 12 Sep 2009
Location: Afton MN
Points: 41609 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Coke-in-MN Quote  Post ReplyReply Direct Link To This Post Posted: 24 Oct 2021 at 3:41pm
if the drive or driven gear are bad - good luck in finding them - 
Lower outer bearing went out in my machine and I had the case machined to accept new bearing cup , with all the work it was $400 a side to do them + cost of new bearings , seals and axle added after .
Faith isn't a jump in the dark. It is a walk in the light. Faith is not guessing; it is knowing something.
"Challenges are what make life interesting; overcoming them is what makes life meaningful."
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.079 seconds.


Help Support the
Unofficial Allis Forum