![]() |
This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | |||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
WTB fuel line |
Post Reply ![]() |
Author | |
DCAC ![]() Orange Level ![]() Joined: 20 Oct 2018 Location: east central SD Points: 511 |
![]() ![]() ![]() ![]() ![]() Posted: 13 Jun 2021 at 12:53pm |
Looking for a good used, or new, fuel line for a 170 gas, black stripe. Thank you!
|
|
![]() |
|
Sponsored Links | |
![]() |
|
DSeries4 ![]() Orange Level ![]() ![]() Joined: 12 Sep 2009 Location: Ontario, Canada Points: 7256 |
![]() ![]() ![]() ![]() ![]() |
Buy some steel brake line and some tube benders and make your own. Pretty easy. I have made a few. |
|
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '61 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080
|
|
![]() |
|
DCAC ![]() Orange Level ![]() Joined: 20 Oct 2018 Location: east central SD Points: 511 |
![]() ![]() ![]() ![]() ![]() |
Thanks DSeries 4, I got some tubing at napa but it kinked too easy in the bender. Might use what didn't kink and splice in a rubber hose and in line filter temporarily as the tank was really rusty/gunky. Got it cleaned out, but don't want to mess up an expensive carb rebuild. Probably end up repairing the original line to use in the future if I can't find a replacement
|
|
![]() |
|
Ed (Ont) ![]() Orange Level ![]() ![]() Joined: 08 Nov 2009 Location: New Lowell, Ont Points: 1232 |
![]() ![]() ![]() ![]() ![]() |
How sharp a bend do you need. Usually can do at least a 90 with no problem. Brake line is cheap. Buy a roll and start practicing. 20ft coil is maybe $25. If the steel is too hard for you use copper nickel line. It is real easy to bend. It does turn green after awhile so clean it occasionally or paint it.
|
|
![]() |
|
DCAC ![]() Orange Level ![]() Joined: 20 Oct 2018 Location: east central SD Points: 511 |
![]() ![]() ![]() ![]() ![]() |
Thanks Ed, I'll try that, 90 degrees is the most bend I need
|
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |