This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


WD WIRING
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
davegoodell View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 07 Jul 2019
Location: eagan, mn
Points: 14 		Post Options Post Options   Thanks (0) Thanks(0)   Quote davegoodell Quote  Post ReplyReply Direct Link To This Post Topic: WD WIRING
    Posted: 07 Jul 2019 at 2:05pm
i NEED HELP WIRING A WD.  iT WORKED PREVIOUSLY BUT HAS A SHORT SOMEWHERE.
i HAVE A 3 POLE LITE SWITCH AND A 2 POLE CUT OUT REGULATOR IN THE LITTLE DASH BOARD.  hELP?
Back to Top
Sponsored Links


Back to Top
AC720Man View Drop Down
Orange Level
Orange Level
Avatar

Joined: 10 Oct 2016
Location: Shenandoah, Va
Points: 5226 		Post Options Post Options   Thanks (0) Thanks(0)   Quote AC720Man Quote  Post ReplyReply Direct Link To This Post Posted: 07 Jul 2019 at 4:57pm
What symptoms are you having?Has a short somewhere? Did it blow the fuse? Wiring in a WD is very simple. Wiring issues were generally at the lights. They tee just under the gas tank where the light holding rods attach. I had to replace the wiring through each tube. Buy a new harness if the insulation is falling off. Cloth goes bad over time and causes shorts or grounds out.
1968 B-208, 1976 720 (2 of them)Danco brush hog, single bottom plow,52" snow thrower, belly mower,rear tine tiller, rear blade, front blade, 57"sickle bar,1983 917 hydro, 1968 7hp sno-bee, 1968 190XTD
Back to Top
davegoodell View Drop Down
Bronze Level
Bronze Level
Avatar

Joined: 07 Jul 2019
Location: eagan, mn
Points: 14 		Post Options Post Options   Thanks (0) Thanks(0)   Quote davegoodell Quote  Post ReplyReply Direct Link To This Post Posted: 07 Jul 2019 at 6:00pm
The wires heat up and the lites don't work and the ammetyer gauge doesn't work.  The gauge is new also.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.


Help Support the
Unofficial Allis Forum