| Author |
 Topic Search  Topic Options
|
BennyLumpkin 
Orange Level
Joined: 22 Mar 2010
Location: Centre Hall, PA
Points: 2657
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: WC final drive seals....
Posted: 01 Sep 2010 at 3:44pm |
|
how hard are they to find, and how hard are they to replace?? my WC sat quite awhile before I bought it and I have been running it quite a bit and they leak terribly now.
|
|
Central PA Allis Express
1934 WC254
1945 WF
1945 WC135755
1951 WD68085
1953 WD45-150217
1957 WD45D-230744D
B110
|
 |
|
Sponsored Links
|
|
|
Gary in Texas
Orange Level
Joined: 11 Sep 2009
Location: Burkburnett, TX
Points: 630
|
Post Options
Thanks(0)
Quote Reply
Posted: 01 Sep 2010 at 3:53pm |
call Brenda, at Sandy Lake Imp. I got my WC seal from her.
Sponser of the site.
Take a little effort to get the pinion shaft out to replace that seal, but not too bad a job.
|
|
CTuckerNWIL
Orange Level
Joined: 11 Sep 2009
Location: NW Illinois
Points: 22823
|
Post Options
Thanks(0)
Quote Reply
Posted: 01 Sep 2010 at 4:01pm |
|
When I read "final drive seal" I think of the big cork seal for the wheel hub. Rubber replacements are available for these from AGCO and all you have to do is pull the wheel off and remove the seal retainer. Last I heard they were $30 or so apiece.
|
|
|
|
BennyLumpkin
Orange Level
Joined: 22 Mar 2010
Location: Centre Hall, PA
Points: 2657
|
Post Options
Thanks(0)
Quote Reply
Posted: 01 Sep 2010 at 4:05pm |
|
I havent pulled the wheels to see which seal it is, but oil all but runs out of them now.
|
|
Central PA Allis Express
1934 WC254
1945 WF
1945 WC135755
1951 WD68085
1953 WD45-150217
1957 WD45D-230744D
B110
|
|
CTuckerNWIL
Orange Level
Joined: 11 Sep 2009
Location: NW Illinois
Points: 22823
|
Post Options
Thanks(0)
Quote Reply
Posted: 01 Sep 2010 at 4:19pm |
|
The seals on the pinion shaft would let differential lube or final drive lube get on the brakes and run off would be higher up than the wheel hub seal leaking.
|
|
|
|
Gary in Texas
Orange Level
Joined: 11 Sep 2009
Location: Burkburnett, TX
Points: 630
|
Post Options
Thanks(0)
Quote Reply
Posted: 01 Sep 2010 at 8:01pm |
if it is the pinion shaft seals, there is a hole in the bottom front of where the brakes are, and it would leak out there.
if it is the big hub seals it will be all over the inside of the wheel and some on the outsida.
Edited by Gary in Texas - 01 Sep 2010 at 8:02pm
|
|
