H4 ALLIS SNAP RING

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I am not having any luck getting the snap ring that goes on the bull gear inside the case. small snap ring that is against the inner thrust bearing. the ends of the snap rings are sort of dished out. when I use the snap ring I have the snap ring sort of twists and I cant get it on. tried to upload a photo but don't thin it is doing it. it looks as though I need a special type of snap ring pliers. im sure some one on here has done it so what type of snap ring pliers did you use. need some advice on how to get the snap ring on. book says you can replace the seals and bearing without taking the case off but its sure wearing me out Thanks  norm

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
pinball Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Access Joined: 28 May 2014 Location: missouriu Points: 6102	Post Options Post Reply Quote pinball Report Post Thanks(0) Quote Reply Topic: H4 ALLIS SNAP RING Posted: 26 Aug 2018 at 1:57pm
	I am not having any luck getting the snap ring that goes on the bull gear inside the case. small snap ring that is against the inner thrust bearing. the ends of the snap rings are sort of dished out. when I use the snap ring I have the snap ring sort of twists and I cant get it on. tried to upload a photo but don't thin it is doing it. it looks as though I need a special type of snap ring pliers. im sure some one on here has done it so what type of snap ring pliers did you use. need some advice on how to get the snap ring on. book says you can replace the seals and bearing without taking the case off but its sure wearing me out Thanks norm

Sponsored Links

Coke-in-MN Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Access Joined: 12 Sep 2009 Location: Afton MN Points: 41572	Post Options Post Reply Quote Coke-in-MN Report Post Thanks(0) Quote Reply Posted: 26 Aug 2018 at 7:58pm
	I am thinking it was a large pliers like with 2 flat jaws that expand when handles are squeezed together - also had a lock lever to hold ring open . But once ring is onto axle as the shaft is fed through gear just use a pry to slide ring to it's final position in groove
	Faith isn't a jump in the dark. It is a walk in the light. Faith is not guessing; it is knowing something. "Challenges are what make life interesting; overcoming them is what makes life meaningful."