This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


190 weak 3 point
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Dakota Dave View Drop Down
Orange Level
Orange Level
Avatar

Joined: 12 Sep 2009
Location: ND
Points: 3971 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Dakota Dave Quote  Post ReplyReply Direct Link To This Post Topic: 190 weak 3 point
    Posted: 08 Jul 2017 at 12:25pm
My 190 has  a weak 3point. Im moving the pallets of lumber for my new shop.  so I put the Pallet fork on the WD 45. it lifts the front of the tractor about 3 feet off the ground and teeters the stack of lumber. So I put the pallet forks on the 190 it wont budge the stack of lumber.  I picked up one end of the pallet of steel with the WD45 loaderand a strap so i could get the forks under it.  the 190 wont lift it. I dont have a factory three point but a conversion on the snap coupler setup. But I really think it should lift more than it does. is there a relief valve stuck somewhere that I should be able to find?
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 21888 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 08 Jul 2017 at 3:47pm
Pressure at any remote outlet when holding a lever into raise or lower should be 2,000 to 2,200 psi with engine half throttle or above. If lower than that....a weak 3 point hitch.
Back to Top
Dakota Dave View Drop Down
Orange Level
Orange Level
Avatar

Joined: 12 Sep 2009
Location: ND
Points: 3971 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Dakota Dave Quote  Post ReplyReply Direct Link To This Post Posted: 08 Jul 2017 at 10:11pm
Thanks I'll try to get a guage next week when I'm at the farm. If I speed it up to 1500 rpm it works much faster.
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 21888 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 09 Jul 2017 at 12:24pm
Hyd on a WD45 will work at an idle.  190 XT at an idle won't do much at all.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.043 seconds.


Help Support the
Unofficial Allis Forum