| Author |
 Topic Search  Topic Options
|
DSeries4 
Orange Level
Joined: 12 Sep 2009
Location: Ontario, Canada
Points: 7509
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: D15 II manifold
Posted: 30 Jul 2016 at 9:25am |
|
Is there any way to keep the pipe that threads into the manifold from working its way loose? I tighten it down with a pipe wrench but will be loose 10 minutes later. I do not want to weld it in place.
I appreciate any ideas!
|
|
'49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '63 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080
|
 |
|
Sponsored Links
|
|
|
wfmurray
Orange Level
Joined: 13 Sep 2009
Location: Bostic NC
Points: 1225
|
Post Options
Thanks(0)
Quote Reply
Posted: 30 Jul 2016 at 9:36am |
|
Bore side and put in setscrew.
|
|
Don(MO)
Orange Level
Joined: 12 Sep 2009
Location: Bates City MO.
Points: 6862
|
Post Options
Thanks(0)
Quote Reply
Posted: 30 Jul 2016 at 9:38am |
|
Look the threads inside the manifold and the ex pipe first, if they are good and the pipe threads down inside the manifold good then remove the pipe and start and run the tractor in tell it's up to temp them install the cold pipe in a hot manifold, get it cool down and see if it stays put.
|
|
3 WD45's with power steering,G,D15 fork lift,D19, W-Speed Patrol, "A" Gleaner with a 330 corn head,"66" combine,roto-baler, and lots of Snap Coupler implements to make them work for their keep.
|
|
bradley6874
Orange Level
Joined: 05 Sep 2010
Location: salisbury md
Points: 1349
|
Post Options
Thanks(0)
Quote Reply
Posted: 30 Jul 2016 at 10:18am |
|
Finda tap clean the thread's up take a torch heat the manifold good and hot then quickly screw a cold new nipple in and tighten with a pipe wrench when it cools it will be there forever
|
|
You can wash the dirt off the body but you can’t wash the farmer out of the heart and soul
|
|
