This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


CA hydraulic pump
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Dakota Dave View Drop Down
Orange Level
Orange Level
Avatar

Joined: 12 Sep 2009
Location: ND
Points: 3960 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Dakota Dave Quote  Post ReplyReply Direct Link To This Post Topic: CA hydraulic pump
    Posted: 09 Mar 2010 at 8:02pm
I've had my Hyd pump apart three times. evry time I put it back it will lift the loader up and then I put the loader down it won't go up again. the pump works good. I put new piston springs and a control valve spring in it. this last time  I found the pin in the drawbar lockout lever was broken. so I changed it. same thing. If I take the drawbar control section off don't change anything and reinstall it then it works one time and stops again. Any ideas whats wrong?
Back to Top
Sponsored Links


Back to Top
caRon View Drop Down
Silver Level
Silver Level


Joined: 14 Sep 2009
Location: Indiana
Points: 298 		Post Options Post Options   Thanks (0) Thanks(0)   Quote caRon Quote  Post ReplyReply Direct Link To This Post Posted: 10 Mar 2010 at 5:45am
Dave is your fluid level full, it will take a couple extra qts of hyd fluid to run a loader on the ca. Sometimes the balls can get out of round and will not seal properly, agco still sells them really cheap. Ron
Back to Top
Dakota Dave View Drop Down
Orange Level
Orange Level
Avatar

Joined: 12 Sep 2009
Location: ND
Points: 3960 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Dakota Dave Quote  Post ReplyReply Direct Link To This Post Posted: 10 Mar 2010 at 6:39am
The fluid is full and the check balls are perfect. The hand lever dosen't feel rigtht after I cycle it from up to down.  I'm taking the Draw bar controll off again today  to see Why its not operating the control valve.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.094 seconds.


Help Support the
Unofficial Allis Forum