This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


WD spindle shaft bearing ??
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Gary in da UP View Drop Down
Orange Level
Orange Level
Avatar

Joined: 13 Sep 2009
Location: EUP of Mi.
Points: 1885 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Gary in da UP Quote  Post ReplyReply Direct Link To This Post Topic: WD spindle shaft bearing ??
    Posted: 24 Feb 2010 at 1:47pm
 Would anyone be able to provide the Timkin # for the bearing and race for the WD spindle shaft lower bearing?  Thanks, Gary
Back to Top
Sponsored Links


Back to Top
j.w.freck View Drop Down
Orange Level
Orange Level
Avatar

Joined: 16 Sep 2009
Location: karnack texas
Points: 1153 		Post Options Post Options   Thanks (0) Thanks(0)   Quote j.w.freck Quote  Post ReplyReply Direct Link To This Post Posted: 25 Feb 2010 at 8:09pm
if you have the old bearing out,and there is a bearing supply store near you,take it to them and they will get you flying again...
Back to Top
Gary in da UP View Drop Down
Orange Level
Orange Level
Avatar

Joined: 13 Sep 2009
Location: EUP of Mi.
Points: 1885 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Gary in da UP Quote  Post ReplyReply Direct Link To This Post Posted: 26 Feb 2010 at 7:34am
 The cone on my bearing is ground away from 65 years of neglect , the race is a link belt #33454x. I don't think a replacement bearing will have rollers that are fatter at the ends and a race that is convex. The closest bearing supply is 150+ miles away ,unless I were to cross over into Canada, and that is a big hassle for a bearing. Living in the UP has its  disadvantages. If no one here can help the I'll fork  my $$$ to AGCO.  Thanks, Gary
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.035 seconds.


Help Support the
Unofficial Allis Forum