This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


7020 hydraulic oil from trans to rear
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
BillinAlberta View Drop Down
Silver Level
Silver Level
Avatar

Joined: 12 Sep 2009
Location: Saskatchewan
Points: 342 		Post Options Post Options   Thanks (0) Thanks(0)   Quote BillinAlberta Quote  Post ReplyReply Direct Link To This Post Topic: 7020 hydraulic oil from trans to rear
    Posted: 26 Sep 2023 at 7:06pm
Well the engine is runnung fine(more on a seperate post)but the oil is going fast into the rear case and out of the transmission .According to the manual there are 2 areas to look at.
   Pump is out and I have ordered the seal that is recommended to change but the seal that is there LOOKS not too bad.It will get replaced.
   The book also recommends pulling the range shift cover and sealing up the core plug.I have gone through that manual and can't find a location for the Range Shift Cover.Is the cover(aluminum)on the right side with all the levers and valves under the batteries the right one?If I remove it are there any special precautions ? It looks like it might be a nightmare if not done properly.
    I really appreciate all the advice given on here.Hopefully my "Big Al" will run again.
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20479 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 26 Sep 2023 at 7:48pm
Going fast, as in how fast ?? Last time I heard about something like this, the oil cooler/radiator area had been worked on and two hoses got reconnected wrong.
Back to Top
BillinAlberta View Drop Down
Silver Level
Silver Level
Avatar

Joined: 12 Sep 2009
Location: Saskatchewan
Points: 342 		Post Options Post Options   Thanks (0) Thanks(0)   Quote BillinAlberta Quote  Post ReplyReply Direct Link To This Post Posted: 26 Sep 2023 at 10:22pm
I just ran outside in my pj's and checked.You could be right.I will have to check tomorrow.
Yes I changed engines and those lines were off.
Back to Top
Lynn Marshall View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 13 Sep 2009
Location: Dana, Iowa
Points: 2282 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Lynn Marshall Quote  Post ReplyReply Direct Link To This Post Posted: 27 Sep 2023 at 7:37am
The aluminum cover is the power shift valve body. The range cover is further back behind the small fuel tank. I don't think that is your problem.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.109 seconds.


Help Support the
Unofficial Allis Forum