This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


D-10 sleeve standout
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
tractorboy View Drop Down
Silver Level
Silver Level


Joined: 03 Oct 2009
Location: southern Va
Points: 474 		Post Options Post Options   Thanks (0) Thanks(0)   Quote tractorboy Quote  Post ReplyReply Direct Link To This Post Topic: D-10 sleeve standout
    Posted: 21 Jul 2022 at 3:29pm
Checked sleeve standout on son's d 10 [reliance kit], two are dead flat even, 2 are maybe .001. Book calls for .002-.005 .  Even though the book says "DO NOT USE BLOCK SEALER'  I kinda want to put a tiny line around the flange. Do any of y'all pros do this ???  thanks keith so. va.
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 21818 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 21 Jul 2022 at 6:48pm
Hopefully you installed the sleeves without the O-rings to measure stand-out. I think I'd remove all of them and measure the thickness of the flanges to see if the workmanship is the problem. They should all be the same.
Back to Top
Alex09(WI) View Drop Down
Orange Level
Orange Level
Avatar

Joined: 15 Mar 2012
Location: CECIL WI
Points: 1747 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Alex09(WI) Quote  Post ReplyReply Direct Link To This Post Posted: 21 Jul 2022 at 6:53pm
Can't speak to the D10 engines, but my experience with WD-D17-170 engine sleeves is they are made wrong. The aftermarket sleeve flanges are made too thick giving too much standout. So it is possible that the sleeves are made wrong.
www.awtractor.com
A&W TRACTOR 920-598-1287
KEEPING ALLIS-CHALMERS IN THE FIELDS THROUGH THE 21ST CENTURY
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.059 seconds.


Help Support the
Unofficial Allis Forum