WD45 Clutch Bearing Assembly Correct?

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Just want to make sure I installed the new clutch Bearing correctly that goes on the clutch shaft gear and fits between the rearend transmission and hand clutch assembly. When I bolted the two together the large snape ring is between the two housings and seems to leave a small cap at the top end when bolted together is this normal?

Jim

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Zyta Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 19 Jan 2010 Location: Ontario Points: 238	Post Options Post Reply Quote Zyta Report Post Thanks(0) Quote Reply Topic: WD45 Clutch Bearing Assembly Correct? Posted: 30 Aug 2010 at 9:57pm
	Just want to make sure I installed the new clutch Bearing correctly that goes on the clutch shaft gear and fits between the rearend transmission and hand clutch assembly. When I bolted the two together the large snape ring is between the two housings and seems to leave a small cap at the top end when bolted together is this normal? Jim

Sponsored Links