This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity. | ||||||
The Forum | Parts and Services | Unofficial Allis Store | Tractor Shows | Serial Numbers | History |
Field cultivator??? |
Post Reply |
Author | |
Mikez
Orange Level Access Joined: 16 Jan 2013 Location: Usa Points: 8085 |
Post Options
Thanks(0)
Posted: 27 May 2022 at 9:45pm |
Hello everyone
I know this has been talked about. Which one is better. And what’s the difference. Between 1200, 1300 and 1400. Then there’s a 1250. Thank you
|
|
Sponsored Links | |
DrAllis
Orange Level Access Joined: 12 Sep 2009 Points: 19326 |
Post Options
Thanks(0)
|
All have 6 inch shank spacing, EXCEPT the 1400, which has 7 or 9 inch shank spacing. The bigger the number the more width available and four tool bars instead of three. Don't remember a 1250 but do remember a 1350. There's also a 1300-E, which had the center tongue tubes going over the top of the frame to prevent trash plugging.
|
|
Mikez
Orange Level Access Joined: 16 Jan 2013 Location: Usa Points: 8085 |
Post Options
Thanks(0)
|
Thanks dr. The 1250 I see was DA.
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |