This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Other Topics > Pulling Forum
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


Bareback 190xt

 Post Reply Post Reply Page  <12
Author
Message
O.P.S. Heads View Drop Down
Orange Level Access
Orange Level Access


Joined: 02 Jan 2013
Location: Iowa
Points: 574
Post Options Post Options   Thanks (0) Thanks(0)   Quote O.P.S. Heads Quote  Post ReplyReply Direct Link To This Post Posted: 08 Dec 2014 at 12:54pm
I have used a round stock of aluminum turned on a lathe to the correct dimension with a shoulder on it so you can drive it in until it hits the shoulder. Use silicone to seal. There may be a piece of PVC pipe that could be made fit wit a cap on it as well. I never have found a freeze plug the correct size.

Edited by O.P.S. Heads - 08 Dec 2014 at 12:55pm
Back to Top
Sponsored Links


Back to Top
 Post Reply Post Reply Page  <12
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.078 seconds.


Help Support the
Unofficial Allis Forum