This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


8070 with a 540 pto
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
BStone View Drop Down
Orange Level
Orange Level
Avatar

Joined: 15 Sep 2009
Location: Texas
Points: 2847 		Post Options Post Options   Thanks (0) Thanks(0)   Quote BStone Quote  Post ReplyReply Direct Link To This Post Topic: 8070 with a 540 pto
    Posted: 22 Sep 2010 at 6:22am
I've been told I can switch a 540-1000 pto from a AC7045 into my AC8070.Can this be done?How big of a job is it to do?IWill you only have to go through the back of the rear end where the pto is at?
Back to Top
Sponsored Links


Back to Top
Troy View Drop Down
Silver Level
Silver Level


Joined: 11 Oct 2009
Location: MN
Points: 75 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Troy Quote  Post ReplyReply Direct Link To This Post Posted: 22 Sep 2010 at 7:00am
yes you do it from the back, drain oil, remove bottom plate take lower shaft out and then the upper clutch shaft out as you will have to add the 540 gear in place of spacer, not bad i can do it in about 4hrs but probably 6 or so for first time.
Back to Top
BStone View Drop Down
Orange Level
Orange Level
Avatar

Joined: 15 Sep 2009
Location: Texas
Points: 2847 		Post Options Post Options   Thanks (0) Thanks(0)   Quote BStone Quote  Post ReplyReply Direct Link To This Post Posted: 22 Sep 2010 at 8:37am
When you do this will you then only have the 540 pto in the 8070?
Back to Top
Lynn Marshall View Drop Down
Orange Level Access
Orange Level Access
Avatar

Joined: 13 Sep 2009
Location: Dana, Iowa
Points: 2316 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Lynn Marshall Quote  Post ReplyReply Direct Link To This Post Posted: 22 Sep 2010 at 12:56pm
No,you would have both 540 and 1000,just like the 7045.
Back to Top
BStone View Drop Down
Orange Level
Orange Level
Avatar

Joined: 15 Sep 2009
Location: Texas
Points: 2847 		Post Options Post Options   Thanks (0) Thanks(0)   Quote BStone Quote  Post ReplyReply Direct Link To This Post Posted: 22 Sep 2010 at 4:47pm
Thanks for all the information.So I put the spacer on the shaft where the 540 gear comes out of the 7045? and then the 7045 will still have a 1000 pto shaft? Would I be wise to buy a used 540 gear and put in the 8070 and just leave the 7045 alone? Thanks again for the help.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.063 seconds.


Help Support the
Unofficial Allis Forum