This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
The Forum Parts and Services Unofficial Allis Store Tractor Shows Serial Numbers History
Forum Home Forum Home > Allis Chalmers > Farm Equipment
  New Posts New Posts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login


7000 Brake Cover Gasket
 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Hurst View Drop Down
Orange Level
Orange Level


Joined: 11 Sep 2009
Location: Midway, Ky
Points: 1211 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Hurst Quote  Post ReplyReply Direct Link To This Post Topic: 7000 Brake Cover Gasket
    Posted: 26 Nov 2023 at 8:52am
Looking at the parts manual for the 7000 brake setup, it shows a qty of 4 brake cover gaskets.  I only had one on each side.  Are these gaskets supposed to be doubled up to shim the cover out, or is it a typo in the manual?  It's part number 70260813.  

Hurst
1979 Allis Chalmers 7000
5800 Hours
Back to Top
Sponsored Links


Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20185 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 26 Nov 2023 at 10:31am
Used as shims. Remove them as disc lining gets worn. New springs. Grease the ball pockets and outer rub areas (four) so nothing sticks or binds.
Back to Top
Hurst View Drop Down
Orange Level
Orange Level


Joined: 11 Sep 2009
Location: Midway, Ky
Points: 1211 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Hurst Quote  Post ReplyReply Direct Link To This Post Posted: 26 Nov 2023 at 1:29pm
So if I'm having my discs relined, should I install with 2 gaskets on each side?  Or is there a good method for knowing target thickness?

Also, on the greasing part, where are the rub areas?  Is that the part of the actuating disc that engages the brake housing?  And what kind of grease do you find works best?  I have some moly spray, would that be better so things don't gum up?

Hurst
1979 Allis Chalmers 7000
5800 Hours
Back to Top
DrAllis View Drop Down
Orange Level Access
Orange Level Access


Joined: 12 Sep 2009
Points: 20185 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrAllis Quote  Post ReplyReply Direct Link To This Post Posted: 26 Nov 2023 at 1:31pm
Put it together with no shims and if you can turn the wheel, it ain't too tight. LOOK at the brake plates. There are four places that position them inside the brake housing. Any grease is better than nothing, gummy or not. Spray grease? prob not.....gun grease....wheel; brg grease....
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.117 seconds.


Help Support the
Unofficial Allis Forum