Farm Equipment - 8010 low pressure hydraulic line

Print Page | Close Window

8010 low pressure hydraulic line

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=212124
Printed Date: 17 Sep 2026 at 2:40pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: 8010 low pressure hydraulic line

Posted By: PawPaw
Subject: 8010 low pressure hydraulic line
Date Posted: 31 Aug 2026 at 11:32am

Where is the best place to plumb into for return line on sprayer with hydraulic pump?

Replies:

Posted By: DrAllis
Date Posted: 31 Aug 2026 at 11:55am

A "case-drain" line ??? There are two hoses on a sprayer pump (in and out) and this is the third line/hose??

Posted By: PawPaw
Date Posted: 31 Aug 2026 at 12:08pm

Only 2 lines to hydraulic motor pressure and return. Sorry for not being clear. Sprayer manual says best to not hook return line to remote coupler.

Posted By: DrAllis
Date Posted: 31 Aug 2026 at 12:37pm

#1. Remove lower sight glass and adapt an O-ring fitting into that hole and check your oil level using the top sight glass. #2. Plug in your second hose to the other remote valve and place that valve in FLOAT and wire it into float so it can't be bumped into HOLD. #3. Remove the steel plate under the PTO gears and above the drawbar and drill/tap a connection into that plate with a coupler to plug your hose into.

Posted By: PawPaw
Date Posted: 31 Aug 2026 at 1:01pm

Thank you