D17 Series IV Steering Control Valve Input Seal

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I am in the middle of replacing the steering U-joints on my D17 Series IV. In the process, I realized that my primary steering system leak is coming from the Steering Control Valve Input Shaft Seal, item 3 in the diagram below. My manual says to overhaul the steering control valve, the front support needs to be removed. Can I replace this seal without completely overhauling the entire steering valve? The input shaft has "splines" on it that it appears would damage the seal on installation. I'm not sure why this part of the shaft is splined, since the force is transferred through the coupler via the roll pin.
uploads/18706/Steer_Control_Val.png

Edited by conquest87tsi - 2 hours 25 minutes ago at 10:14am

	This site is not affiliated with AGCO Inc., Duluth GA., Allis-Chalmers Co., Milwaukee, WI., or any surviving or related corporate entity. All trademarks remain the property of their respective owners. All information presented herein should be considered the result of an un-moderated public forum with no responsibility for its accuracy or usability assumed by the users and sponsors of this site or any corporate entity.
	The Forum	Parts and Services	Unofficial Allis Store	Tractor Shows	Serial Numbers	History

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
conquest87tsi Members Profile Send Private Message Find Members Posts Add to Buddy List Bronze Level Joined: 14 Jul 2018 Location: Minnesota Points: 6	Post Options Post Reply Quote conquest87tsi Report Post Thanks(0) Quote Reply Topic: D17 Series IV Steering Control Valve Input Seal Posted: 2 hours 26 minutes ago at 10:13am
	I am in the middle of replacing the steering U-joints on my D17 Series IV. In the process, I realized that my primary steering system leak is coming from the Steering Control Valve Input Shaft Seal, item 3 in the diagram below. My manual says to overhaul the steering control valve, the front support needs to be removed. Can I replace this seal without completely overhauling the entire steering valve? The input shaft has "splines" on it that it appears would damage the seal on installation. I'm not sure why this part of the shaft is splined, since the force is transferred through the coupler via the roll pin. uploads/18706/Steer_Control_Val.png Edited by conquest87tsi - 2 hours 25 minutes ago at 10:14am

Sponsored Links

Alvin M Members Profile Send Private Message Find Members Posts Add to Buddy List Orange Level Joined: 24 Jun 2018 Location: PA Points: 859	Post Options Post Reply Quote Alvin M Report Post Thanks(0) Quote Reply Posted: 1 hour 44 minutes ago at 10:55am
	You can replace the seal with out taking it apart I never saw a splined shaft if it is splined put tape on splines