| Author |
|
mdm1 
Orange Level
Joined: 12 Sep 2009
Location: Onalaska, WI
Points: 2678
|
 Post Options
 Thanks(0)
 Quote  Reply
 Topic: wd-45 lost spark
Posted: 18 Apr 2020 at 5:29pm |
|
The tractor started right up and ran fine. I decided to take it for a short ride. I was going up a slight incline and it quit like it had run out of gas. Fired right back up but did the same thing again. Checked the fuel level with the closest universal fuel gauge and it seemed like maybe going up hill it didn't get gas.(this has been a problem before) Put five gallons of gas in it and no start. Didn't seem like it wanted to fire. 6v system, turned over very good, 6.1v at the battery, 5.3v when cranking. 5.3volts at the - side of coil with the switch on or cranking. Cleaned points, rotor and distributor cap. Checked spark with a good tester-no spark. Checked - terminal and + terminal on coil with a mulimeter. 0.0 Secondary was 8.3. Is my coil shot? Happened like right now. Sorry about the length of this post. Should the primary test around 1.5+-?
|
|
Everything is impossible until someone does it! WD45-trip loader 1947 c w/woods belly mower, 1939 B, #3 sickle mower 1944 B, 2 1948 G's. Misc other equipment that my wife calls JUNK!
|
 |
|
Sponsored Links
|
|
|
MACK
Orange Level
Joined: 17 Nov 2009
Points: 7664
|
Post Options
Thanks(0)
Quote Reply
Posted: 18 Apr 2020 at 10:27pm |
|
I would guess coil or condenser. MACK
|
|
Boss Man
Orange Level
Joined: 03 Mar 2018
Location: Greenleaf, WI
Points: 617
|
Post Options
Thanks(0)
Quote Reply
Posted: 19 Apr 2020 at 8:22am |
|
I'm with MACK
|
|
Sugarmaker
Orange Level
Joined: 12 Jul 2013
Location: Albion PA
Points: 8525
|
Post Options
Thanks(0)
Quote Reply
Posted: 19 Apr 2020 at 8:23am |
I have run them out of gas many times! I mean many times! One thing I forget to do is turn the fuel on sometimes too. Thats a easy fix.:) Check for fuel again at the carb. If it has a drain on the bottom, which it should have open that and check for fuel flow too. Man I think back of the thousands of hours My Dad and I spent on these with so little maintenance. Good luck getting it running again. Regards, Chris
|
|
D17 1958 (NFE), WD45 1954 (NFE), WD 1952 (NFE), WD 1950 (WFE), Allis F-40 forklift, Allis CA, Allis D14, Ford Jubilee, Many IH Cub Cadets, 32 Ford Dump, 65 Comet.
|
|
mdm1
Orange Level
Joined: 12 Sep 2009
Location: Onalaska, WI
Points: 2678
|
Post Options
Thanks(0)
Quote Reply
Posted: 19 Apr 2020 at 8:50am |
|
Chris I did check the gas flow. My problem is my tactors are 2hrs away so I need to take the parts I hope I need. To hard to parts chase. I think I will get a coil and tuneup kit and take a drive. I have to add. One multimeter will go as low as 200 on the ohms and then on the primaries reads 1.5, 2000 reads 1. After that it reads 00. The other one only goes down to 2k and reads 00
|
|
Everything is impossible until someone does it! WD45-trip loader 1947 c w/woods belly mower, 1939 B, #3 sickle mower 1944 B, 2 1948 G's. Misc other equipment that my wife calls JUNK!
|
|
Ted J
Orange Level
Joined: 05 Jul 2010
Location: La Crosse, WI
Points: 18943
|
Post Options
Thanks(0)
Quote Reply
Posted: 20 Apr 2020 at 11:28am |
|
The condenser I would think of second, especially if it is an old one made in the US. If it is China junk, yes it's probably bad.
But I'd think it's the coil first......
But then, thinking,,,,,,and yes, it does hurt,,,,, start checking the continuity of the various wires themselves for an open. Solid wires on these old girls have a tendency to snap and cause an open. Hope this helps....
Looks like we may not get our breakfast for quite some time now....what with our dictator governor.
Hey Thad, want a governor??
|
|
"Allis-Express"
19?? WC / 1941 C / 1952 CA / 1956 WD45 / 1957 WD45 / 1958 D-17
|
|
mdm1
Orange Level
Joined: 12 Sep 2009
Location: Onalaska, WI
Points: 2678
|
Post Options
Thanks(0)
Quote Reply
Posted: 20 Apr 2020 at 3:02pm |
|
Update. I took a new coil and a tuneup kit. Bought the parts at a farm store. Sorry but only place I could get them on my time shedule. Got some good ideas from Lon(MN). Had juice at the - side of the coil. Checked the points for spark. Had spark. Still no spark at the plug wires. At Lon's suggestion I ran a jumper from the hot wire on the starter to the - on coil. Put in new points, condenser and rotor. Fired right up. Took off jumper and hooked the wire back up to coil. Started and ran. For some reason I thought I would check the volts at the battery when it was running. Pulled out the switch to see if it would increase. The tractor shut off like I had turned the key. Opened the switch box and nothing looked bad. (new 3way switch) Unhooked the -wire on coil and hooked up jumper. Fired right up. Going to rewire it, get a voltage regulator and a push pull switch for the lights.
|
|
Everything is impossible until someone does it! WD45-trip loader 1947 c w/woods belly mower, 1939 B, #3 sickle mower 1944 B, 2 1948 G's. Misc other equipment that my wife calls JUNK!
|
|
mdm1
Orange Level
Joined: 12 Sep 2009
Location: Onalaska, WI
Points: 2678
|
Post Options
Thanks(0)
Quote Reply
Posted: 30 Apr 2020 at 6:55pm |
|
Update. I ordered a 6v voltage regulator from Steve(B&B). Installed the voltage regulator. Rewired the entire tractor except the lights. Will do those later as I don't use them anyway. Really cleaned up the junction box on the tractor. Everything worked as it should. Happy tractor. Thanks for all the suggestions!
|
|
Everything is impossible until someone does it! WD45-trip loader 1947 c w/woods belly mower, 1939 B, #3 sickle mower 1944 B, 2 1948 G's. Misc other equipment that my wife calls JUNK!
|
|
Dave(inMA)
Orange Level
Joined: 12 Sep 2009
Location: Grafton, MA
Points: 2399
|
Post Options
Thanks(0)
Quote Reply
Posted: 30 Apr 2020 at 7:26pm |
|
Hey - it's great to win one of these battles!! Good to hear.
|
|
WC, CA, D14, WD45
|
|
Topic Options