Farm Equipment - wanted IB parts

Print Page | Close Window

wanted IB parts

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=8877
Printed Date: 01 Feb 2025 at 3:03am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: wanted IB parts

Posted By: lukeWI
Subject: wanted IB parts
Date Posted: 02 Mar 2010 at 7:02pm

i am looking for anyone who has some Ib parts or has parted out an IB. i am needing a steering column, left fender, draw bar set up, choke and starter rod. thanks for any help, either send me a message or call me at 715-317-0017. thanks

Replies:

Posted By: steve(ill)
Date Posted: 02 Mar 2010 at 9:02pm

luke, if you dont get any takers--- you can cut down a B steering column to make that, you can modify a WD fender to use on the IB, and the choke and starter rod can be made from round bar stock.

-------------
Like them all, but love the "B"s.

Posted By: GlenninPA
Date Posted: 02 Mar 2010 at 9:11pm

luke,

Are you looking for the steering column tube, or the shaft with the worm on the end?

If you are looking for the shaft with the worm gear, I could measure the NOS one I have here for you. You would need to take a regular B shaft and cut a piece out of the middle and reweld it. It is hollow, so you should be able to put a rod inside to reinforce the joint area. If it is just the tube, they are easily made from some thinwall tubing.

Glenn

Posted By: Herb(GA)
Date Posted: 02 Mar 2010 at 9:23pm

Roger VanCamp has some IB's being parted; ph 260-747-3455. Fort Wayne, IN, near the airport. Leave it ring a while as Rogers hearing isn't that great, and his pace is getting a little slower; sorta like someone else I know. Herb

Posted By: Cal
Date Posted: 02 Mar 2010 at 9:48pm

Luke I used 2 new fenders from stiener on my IB and they came out good. You need to flatten the forward lower boss to use the WD fender and then copy the flat block off plate from the old IB fender. Cal in Ct.

Posted By: Steve in NJ
Date Posted: 03 Mar 2010 at 11:40am

When I restored my IB, I purchased a couple WD fenders from Tony C. A little bit of alteration that my body man did, using the IB fenders as patterns, and I had a sweet lookin' set of IB fenders! I also made my starter rod and made the rest of the foot throttle linkage that was missing. That was a fun project though I must say...

mailto:Steve@B&B - Steve@B&B