Construction and other equipment - Hd11e track adjuster

Print Page | Close Window

Hd11e track adjuster

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Construction and other equipment
Forum Description: everything else with orange (or yellow) paint
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=70853
Printed Date: 27 Jun 2025 at 9:04pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Hd11e track adjuster

Posted By: 2wise4agm
Subject: Hd11e track adjuster
Date Posted: 25 May 2013 at 8:44am

The seal in the track adjusting cylinder went out and now the track won't tighten. Do I have to split the track to change this, or is there another way? I'm not sure how far the rod goes in there, or how much slack I'm going to need to get it apart. Thanks guys.

Replies:

Posted By: Lazyts
Date Posted: 25 May 2013 at 10:06am

Track adjuster will come out without splitting track- you may have to block the idler, but you just have to lift the front of the adjuster after freeing it from idler pins, then the inner fork will come out past rear of idler and chain near the top. There should be plenty of room when adjuster is retracted. Seals are available from Henderson or Minnpar.

Posted By: 2wise4agm
Date Posted: 25 May 2013 at 11:44am

That's good news. Thank you!