wd pto seal
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=55260
Printed Date: 29 Aug 2025 at 11:34pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: wd pto seal
Posted By: jlogli
Subject: wd pto seal
Date Posted: 14 Aug 2012 at 5:16pm
|
Can you remove the pto seal with out taking the cover off? ------------- 1945 WC on full steel, WD wide front, WD45 power steering, 1966 D-17IVfactory 3 point.1967 D-17IV SC. 1973 rotobaler white top. orange top roto, model 90 combine,82S, four bottom plow.302 baler. |
Replies:
Posted By: CTuckerNWIL
Date Posted: 14 Aug 2012 at 7:01pm
Yep, if you got the right tool. Drill a small hole in the outer edge of the metal and screw a sheet metal screw into it. Grab a hold with a slide hammer tool and tap it out. Best drain the lube out first or you might have BIG wet slippery spot on the floor or driveway My little slide hammer tool is a vise grip. I take the screw out of the handle and put in a piece of threaded rod about 18 inches long. I have a piece of 2 inch cold rolled steel about 3 in long with a hole in it that I put on the threaded rod for a slide hammer and weld a nut on the back end of the threaded rod. ------------- http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF |