Farm Equipment - Looking for special tool

Print Page | Close Window

Looking for special tool

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=54371
Printed Date: 28 Sep 2024 at 8:11am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Looking for special tool

Posted By: JimWenigOH
Subject: Looking for special tool
Date Posted: 29 Jul 2012 at 4:10pm

Anyone have the special socket for the Gleaner 9/16" feeder beater fingers, AC TP 1007, that I could use or buy?

Replies:

Posted By: SteveM C/IL
Date Posted: 29 Jul 2012 at 4:18pm

You can cut a deep well socket in two and weld a length of pipe in between. I just worked through the inspection holes with a hand wrench.Put a little blue loctite on new ones. Can't remember if I was able to get a box end over the end with the guide out or not.

Posted By: XT in pa
Date Posted: 29 Jul 2012 at 9:39pm

i used a pipe wrench but i replaced it and the new one had a hex at the top it was 5/8 on f2

-------------
190XT,D17and 7045

Posted By: JimWenigOH
Date Posted: 30 Jul 2012 at 7:52pm

Never mind. My new fingers are 5/8" with two flats at 1/2" wide on the end, and I don't know if it would use the same tool as the 9/16" fingers. I will grind out a 1/2" square socket to work.