160 diesel oil pressure
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=50322
Printed Date: 22 Nov 2024 at 11:04pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 160 diesel oil pressure
Posted By: AcFordHawk
Subject: 160 diesel oil pressure
Date Posted: 09 May 2012 at 9:19pm
|
Rather lengthy post, working a low oil pressure problem on my 160 with the Perkins 152 diesel. With a cold engine the pressure was 55 psi and would drop to 0 relatively soon as the engine warmed up. I pulled the oil pump out and found it was worn so replaced it. Now has 75-80 psi cold but still after quite a while will eventually drop to 0 or so after warm up. Additional info, the oil filter was a cannister type and the PO must have lost the tension spring as when I pulled it apart the filter was just bouncing around in the housing, probably not filtering. I have since changed it over to a spin on. I have been told the cam bearings could also be a culprit. Can these be replace with the engine in the tractor? The manual I have is not complete on all maintenance aspects. Anything else, main bearings maybe causing the low oil pressure?
|
Replies:
Posted By: dscott
Date Posted: 12 May 2012 at 9:27pm
|
Never worked on that type of perkins. But most engines lube in this order mains,cam then rod bearings. So as long as you didn't find a cracked or leaking pick up pipe, I would look at the rod bearings first. Or maybe an internal oil pipe ,say at the rocker arm area has broken. Are you using a know good oil pressure gauge.
|
|