Styled/unstyled wc transmission ?
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=49304
Printed Date: 24 Aug 2025 at 9:32am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: Styled/unstyled wc transmission ?
Posted By: Thad in AR.
Subject: Styled/unstyled wc transmission ?
Date Posted: 20 Apr 2012 at 6:29pm
| Just wondering if a styled and unstyled wc transmission are the same? I need a new gear shifter or probably a new tower and shifter. |
Replies:
Posted By: norm[ind]
Date Posted: 20 Apr 2012 at 7:04pm
| we have some shift towers 1-574-342-4545 can help |
Posted By: CTuckerNWIL
Date Posted: 20 Apr 2012 at 7:16pm
|
The shift lever is different, a styled shifter will hit the gas tank support on an unstyled tractor when in 1st and 3rd. The housing is also different. Styled tranny has the fill plug in the right front corner and the unstyled has it on the right in the center. The frame rail toolbox would block the fill hole on an unstyled tractor. All the inards will be the same and the shifter can be switched from one to the other. ------------- http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF |
Posted By: Thad in AR.
Date Posted: 20 Apr 2012 at 7:30pm
| Ok I need a unstyled gearshift or an unstyled shifttower with a gearshift. I welded the groove up and cut a new groove in mine and got all the slop out and made a new pin. I got it all back together and it all worked perfect. I shifted it in all gears and the reverse lockout worked good then I shifted from 2nd to first and the shifter broke off right at the ball. I didn't force it just pushed it forward and it broke. I even wiggled the input shaft to make it go in all the gears easy with out force. Did I get it too hot when I welded the groove shut? |
Posted By: CTuckerNWIL
Date Posted: 20 Apr 2012 at 8:10pm
I cut the bottom 3 inches or so off my original unstyled shifter cause of the rust. I then cut the top off the styled shifter parts donor and welded the old lever on the donor bottom. I still have the slop back and forth but the original ball was GONE. Hope mine don't break ------------- http://www.ae-ta.com" rel="nofollow - http://www.ae-ta.com Lena 1935 WC12xxx, Willie 1951 CA6xx Dad bought new, 1954WD45 PS, 1960 D17 NF |