Farm Equipment - Electronic cut out question

Print Page | Close Window

Electronic cut out question

Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=32687
Printed Date: 07 Oct 2025 at 11:47pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com

Topic: Electronic cut out question

Posted By: Bull
Subject: Electronic cut out question
Date Posted: 22 Jun 2011 at 4:33pm

I am wiring up my CA and have purchased an electronic cut out for the generator. I am wiring as original with 6 volt positive ground. My question is do you hook the + terminal on the cut out to the ammeter or the generator?

Replies:

Posted By: Wes (VA)
Date Posted: 22 Jun 2011 at 4:38pm

terminal that says BAT on the cut out goes to the ammeter. I just ran into this putting my CA back to 6Vpos. grd. The "F"ield is varied by the resistor switch in the dash. A short jumper wire runs from the GEN terminal of the cut out to the "A"rmature post. hope this helps. -Wes

Posted By: Bull
Date Posted: 22 Jun 2011 at 4:46pm

Thanks Wes for the info!

Sam

Posted By: Gerald J.
Date Posted: 22 Jun 2011 at 7:23pm

Quick test. Take the fan belt off. Connect wires to cutout, battery, and generator. If the generator motors the cutout is backwards.

Gerald J.