210 rear brakes
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=22192
Printed Date: 13 Feb 2025 at 1:41am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: 210 rear brakes
Posted By: mark/indiana
Subject: 210 rear brakes
Date Posted: 12 Dec 2010 at 4:41pm
We have replaced the discs and stilll have one brake that willl not activate...has anyone had one apart lately...aren't these two stage brakes...acutuaters and discs should be right ...any help would be appreciated...Mark
-------------
mark/indiana..."My favorite Allis Tractor or Crawler is the one I'm sitting on at the time!!..
|
Replies:
Posted By: nowversatile
Date Posted: 12 Dec 2010 at 6:49pm
|
Have you checked the little steel balls between the actuator plates? They have caused us problems in the past.
|
Posted By: injpumpEd
Date Posted: 12 Dec 2010 at 8:00pm
there are 3 lined discs, one floater, and the actuator assembly. If you didn't pull out all the components, then maybe the discs aren't sliding on the bull pinion. I cleaned mine all up, and one side (right)really grabs good, and the(left) is marginal. I also left the wire spacer out to compensate for the discs being a little thinner. I did sand them while out too.
-------------
210 "too hot to farm" puller, part of the "insane pumpkin posse". Owner of Guenther Heritage Diesel, specializing in fuel injection systems on heritage era tractors. stock rebuilds to all out pullers!
|
Posted By: JK(IN)
Date Posted: 13 Dec 2010 at 9:16am
|
Agree with others...when I had my brakes apart I took all the springs and balls out. Some of the balls were wore flat on one side and couldn't actuate properly. Also, one of the springs was broken. Also, check the free play in the brake pedals. You can get some adjustment out of the rods that actuate the brakes.
|
|