How to with WD Cultivator
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=21983
Printed Date: 12 Feb 2025 at 3:58pm
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: How to with WD Cultivator
Posted By: Ted J
Subject: How to with WD Cultivator
Date Posted: 08 Dec 2010 at 12:33pm
How do the forward sections on a WD cultivator go up and down? I just bought a set of fronts and rears for my WD45 and there is nothing to make the forward sections move. They are wired in place in fact. Any pictures out there? Any help is sure appreciated. Thanks, Ted
-------------
"Allis-Express"
19?? WC / 1941 C / 1952 CA / 1956 WD45 / 1957 WD45 / 1958 D-17
|
Replies:
Posted By: Dans 7080
Date Posted: 08 Dec 2010 at 12:43pm
|
There is a way to unhook one of the rear hydraulic cylinders and it flipps around to raise them, then there is a valve on the pump that you have to change to set it to delayed lift. Im not exactly sure how to do it, but this should give you a start.
|
Posted By: skipwelte
Date Posted: 08 Dec 2010 at 12:48pm
|
there is a backet that mounts on the tractor frame under the gas tank and two steel rods and go fromt he bracket linkage to the cult gangs. You need that bracket and steel rods. An operators manual will show you exactly how to do it. HTH
|
Posted By: Steve M C/IL
Date Posted: 08 Dec 2010 at 1:14pm
|
left cyl unpin at lift arm,swing foward pin to lift bracket
|
Posted By: monitordoc
Date Posted: 08 Dec 2010 at 2:22pm
I HAVE A 2 ROW CULTIVATOR FOR A WD/WD45 WITH ALL OF THE MOUNTING BRAKETS AND LIFT LINKAGE. INTRESTED??
-------------
WD,D17-S4,180,D21
|
Posted By: Ted J
Date Posted: 08 Dec 2010 at 2:26pm
I sent you a PM
-------------
"Allis-Express"
19?? WC / 1941 C / 1952 CA / 1956 WD45 / 1957 WD45 / 1958 D-17
|
Posted By: Bill Long
Date Posted: 08 Dec 2010 at 2:28pm
|
The hyd setting is A screw at bottom of pump screw into detent in pump body, b screw to lock plates together making the hold position, and c screw at the front of the bottle top screwed in to provide delay between the front lift and the rear lift so tracks can be plowed. If additional delay is needed then use the D screw in front of body.
The Hyd Ram linkage was described above.
Good Luck!
Bill long
|
Posted By: KY
Date Posted: 08 Dec 2010 at 2:35pm
|
I have pics of one mounted but I dont have a digital camera. Dont know of any other way to send one.
|
Posted By: Ted J
Date Posted: 08 Dec 2010 at 2:43pm
Do you have a cell phone? You can take pics with that and send them. I sent you my phone # in a PM.
-------------
"Allis-Express"
19?? WC / 1941 C / 1952 CA / 1956 WD45 / 1957 WD45 / 1958 D-17
|
|