d17 iv head light wireing routing
Printed From: Unofficial Allis
Category: Allis Chalmers
Forum Name: Farm Equipment
Forum Description: everything about Allis-Chalmers farm equipment
URL: https://www.allischalmers.com/forum/forum_posts.asp?TID=211245
Printed Date: 23 Oct 2026 at 1:31am
Software Version: Web Wiz Forums 11.10 - http://www.webwizforums.com
Topic: d17 iv head light wireing routing
Posted By: HudCo
Subject: d17 iv head light wireing routing
Date Posted: 31 May 2026 at 9:37pm
| how are all the wires routed for the fender lights, where do the wires go through at the dash area ? |
Replies:
Posted By: PaulB
Date Posted: 01 Jun 2026 at 6:51am
|
I'm guessing it would be much like a D15II. From the dash switch the wire follows along the steel hydraulic line to the left rear axle housing then splits to the left and right sides. ------------- If it was fun to pull in LOW gear, I could have a John Deere. Real pullers don't have speed limits. If you can't make it GO... make it SHINY |
Posted By: only AC orange
Date Posted: 01 Jun 2026 at 7:22am
| Paul is correct! |
Posted By: DSeries4
Date Posted: 01 Jun 2026 at 2:22pm
|
Up through the fender braces too. Goes to the right fender under the panel that covers the hydraulic lines going to the valve body ------------- '49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '63 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080 |
Posted By: HudCo
Date Posted: 01 Jun 2026 at 10:50pm
| been working on trying to get anything up threw thoese old filled with dirt and rust supports in the fenders have been working a fish tape and tye wire |
Posted By: DSeries4
Date Posted: 02 Jun 2026 at 2:52pm
Years ago I used an old bike wheel spoke to clear out the supports. It took a while but it cleared everything out. Doesn't take much for mud and dirt to get packed in there. ------------- '49 G, '54 WD45, '55 CA, '56 WD45D, '57 WD45, '58 D14, '59 D14, '60 D14, '63 D15D, '66 D15II, '66 D21II, '67 D17IV, '67 D17IVD, '67 190XTD, '73 620, '76 185, '77 175, '84 8030, '85 6080 |
HudCo wrote: